Fusion FWD V6-3.0L (2009)
-
damaged pins
-
pushed-out pins
-
Connect the 4X4 control module connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new 4X4 control module. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
T35 CHECK FOR CORRECT IC OPERATION
-
Disconnect the IC connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the IC connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new IC. REFER to Instrument Panel, Gauges and Warning Indicators. CONNECT all modules. CLEAR the DTCs. REPEAT the network
test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
T36 CHECK FOR CORRECT OCSM OPERATION
-
Disconnect the OCSM connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the OCSM connector and make sure it seats correctly.
-
Verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new OCSM. REFER to Air Bag Systems. CONNECT the modules. CLEAR the DTCs.
REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. CONNECT all modules. The concern may have been caused by a loose or corroded connector. REPEAT
the network test with the scan tool.
-------------------------------------------------
T37 CHECK FOR CORRECT RCM OPERATION
-
Disconnect all the RCM connectors.
-
Check for:
-
corrosion
-
damaged pins
