Fusion FWD V6-3.5L (2010)
Arm Rest: Service and Repair
Seat Armrest - Rear
Removal and Installation
All vehicles
1. Remove the 60 percent rear seat backrest. For additional information, refer to Seat Backrest - Rear See: Seats/Seat Back/Service and
Repair/Removal and Replacement/Seat Backrest - Rear.
Hybrid vehicle
2. Remove the 2 pin-type retainers and the duct end seal.
All vehicles
3. Separate the 4 pin-type retainers attaching the armrest pocket cover to the backrest frame.
4. Remove the armrest assembly.
1. Disengage the backrest cover lower J-strips.
2. Remove the 4 armrest-to-backrest bolts and armrest assembly.
-
For installation, adjust the armrest horizontally as needed for good fit.
-
To install, tighten to 10 Nm (89 lb-in).
5. Disassemble the armrest assembly in the following sequence.
1. Remove the cup holder rubber insert.
2. Remove 2 pin-type retainers and the cup holder.
3. Remove 2 armrest pivot bolts and armrest bracket.