Fusion FWD V6-3.5L (2010)
2. Install the 2 rearward backrest-to-floor bolts.
-
Tighten to 47 Nm (35 lb-ft).
3. Position the backrest upright and install the 2 forward backrest-to-floor bolts.
-
Tighten to 47 Nm (35 lb-ft).
4. Check backrest latch and latch release operation.
-
Raise the backrest and check for good backrest fit and latch closure when upright.
-
If necessary, adjust the rear seat latch. For additional information, refer to Seat Latch Adjustment - Rear See: Seat Latch/Adjustments in the
General Procedures portion.
Seat - Exploded View, Front
Seat - Exploded View, Front
Front Seat Backrest without Fold-Flat
NOTE: Driver backrest shown, passenger backrest similar.
