Fusion FWD V6-3.5L (2010)
9. Disassemble the armrest assembly in the following sequence.
1. Remove the cup holder rubber insert.
2. Remove the 2 pin-type retainers and cup holder.
3. Remove 2 armrest pivot bolts and armrest bracket.
-
To install, tighten to 10 Nm (89 lb-in).
10. Disengage 2 backrest cover clips in the armrest pocket.
11. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
backrest foam pad.
Invert the backrest cover up as far as it will go.
-
Separate the hook-and-loop strips and remove all rows of hog rings working up the backrest.
12. NOTE: The head restraint guide sleeves are keyed and will not interchange. To assemble, install the head restraint guide sleeve with the button on
the LH side.
Under the backrest foam pad, squeeze the ends of the head restraint guide sleeves together and remove.
13. Remove the backrest cover and foam pad from the backrest frame.
14. To assemble, reverse the disassembly procedure.
Seat Backrest - Rear, 40 Percent
Seat Backrest - Rear, 40 Percent
