Fusion FWD V6-3.5L (2010)
2. Install the upper intake manifold support bracket bolt.
-
Tighten to 10 Nm (89 lb-in).
3. If equipped, attach the cylinder block heater wiring harness retainer to the upper intake manifold.
4. Attach all the wiring harness retainers to the upper intake manifold.
5. Connect the PCV tube to the PCV valve.
6. Connect the brake booster vacuum hose to the intake manifold.
7. Connect the EVAP tube to the intake manifold. For additional information, refer to Fuel Delivery and Air Induction.
8. Connect the TB electrical connector.
9. Install the ACL outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
