Fusion FWD V6-3.5L (2010)
30. Connect the RH VCT solenoid electrical connector.
31. Connect the PSP switch electrical connector.
32. Connect the RH Catalyst Monitor Sensor (CMS) sensor electrical connector.
33. NOTICE: If the engine is repaired or replaced because of upper engine failure, typically including valve or piston damage, check the
intake manifold for metal debris. If metal debris is found, install a new intake manifold. Failure to follow these instructions can result in
engine damage.
Using new gaskets, install the upper intake manifold and the 6 bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
34. Install the upper intake manifold support bracket bolt.
