Fusion FWD V6-3.5L (2010)
-
Tighten the 2 catalytic converter support bracket bolts to 20 Nm (177 lb-in).
All-Wheel Drive (AWD) vehicles
47. NOTE: A new Power Transfer Unit (PTU) seal must be installed whenever the intermediate shaft is removed.
Install a new PTU seal. For additional information, refer to Ignition System.
All vehicles
48. Using the Powertrain Lift, raise the subframe into the installed position.
49. NOTE: LH shown, RH similar.
Install the 2 front subframe nuts.
-
Tighten to 150 Nm (111 lb-ft).
50. NOTE: LH shown, RH similar.
Position the subframe brackets and install the 4 bolts finger-tight.
Part 2
Engine Front Cover