Fusion FWD V6-3.5L (2010)
Exhaust Resonator: Service and Repair
Resonator - 3.5L
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove and discard the 2 exhaust Y-pipe-to-resonator nuts.
-
Discard the gasket.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Loosen Torca(R) clamp nut.
-
To install, tighten to 47 Nm (35 lb-ft).
4. Separate the resonator from the muffler and tail pipe and remove the resonator.
5. To install, reverse the removal procedure.
-
Install a new gasket and nuts.
6. Start the engine and check for exhaust leaks.