Fusion FWD V6-3.5L (2010)
8. Remove the power steering pump belt.
-
Fold the Stretchy Belt Remover under the inside of the power steering pump belt as shown.
-
In one quick motion, firmly pull the Stretchy Belt Remover out of the RH fender well, removing the power steering pump belt.
Installation
1. Install the power steering belt on the crankshaft pulley.
2. NOTE: After installation, make sure the belt is correctly seated on the crankshaft and power steering pulleys.
Position the power steering belt around the Stretchy Belt Installer Tool and the power steering pulley. Make sure the belt is engaged with the
power steering pulley and rotate the crankshaft clockwise to install the power steering belt.
3. Position the accessory drive belt on the crankshaft pulley.
4. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
5. Install the RH splash shield and the 6 pin-type retainers.
6. Position the RH fender splash shield and install the 4 screws.
