Fusion FWD V6-3.5L (2010)
-
Are the resistances less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to L4.
No
REPAIR the circuit in question. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
L4 CHECK FOR CORRECT DC/DC OPERATION
NOTE: Do not disconnect the high voltage cables or connectors in the following step.
-
Disconnect the DC/DC LOW VOLTAGE connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the DC/DC LOW VOLTAGE connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new DC/DC. REFER to Hybrid Drive Systems. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
Pinpoint Test M: The Audio Control Module (ACM) Does Not Respond To The Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test M: The Audio Control Module (ACM) Does Not Respond To The Scan Tool
Refer to Wiring Diagram Set 14 (Fusion/Milan/MKZ, Fusion Hybrid/Milan Hybrid), Module Communications Network for schematic and connector
information. See: Diagrams/Electrical Diagrams/Diagrams By Number
Refer to Wiring Diagram Set 130 (Fusion/Milan/MKZ, Fusion Hybrid/Milan Hybrid), Audio System/Navigation for schematic and connector
information. See: Diagrams/Electrical Diagrams/Diagrams By Number
Normal Operation
The Audio Control Module (ACM) communicates with the scan tool through the Medium Speed Controller Area Network (MS-CAN).
