ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3243 > < Initial Inspection and Diagnostic Overview|Page 3241
Page 95
background image

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AC19. 

No

CONNECT the negative battery cable. GO to AC60.

-------------------------------------------------
AC19 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IPC DISCONNECTED

 

-

Disconnect: Instrument Panel Cluster (IPC) C220 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an Interior Lighting Control Module (ILCM), GO to AC20. 

If the vehicle is not equipped with an ILCM, GO to AC21. 

No

CONNECT the negative battery cable. GO to AC61.

-------------------------------------------------
AC20 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE ILCM DISCONNECTED

 

-

Disconnect: ILCM C2301 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AC21. 

Initial Inspection and Diagnostic Overview|Page 3243 > < Initial Inspection and Diagnostic Overview|Page 3241