ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3245 > < Initial Inspection and Diagnostic Overview|Page 3243
Page 97
background image

-

Disconnect: DCSM C3305c .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AC25. 

No

CONNECT the negative battery cable. GO to AC64.

-------------------------------------------------
AC25 VERIFY VEHICLE EQUIPMENT - APIM

 

-

Verify whether the vehicle is equipped with an Accessory Protocol Interface Module (APIM).

-

Is the vehicle equipped with an APIM?

Yes

GO to AC26. 

No

GO to AC27.

-------------------------------------------------
AC26 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED

 

-

Disconnect: APIM C3338 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AC27. 

No

CONNECT the negative battery cable. GO to AC65.

-------------------------------------------------
AC27 VERIFY VEHICLE EQUIPMENT - DDM

 

Initial Inspection and Diagnostic Overview|Page 3245 > < Initial Inspection and Diagnostic Overview|Page 3243