Fusion FWD V6-3.5L (2010)
-
4X4 control module (if equipped)
-
ABS module
-
Accessory Protocol Interface Module (APIM) (if equipped)
-
Air Conditioning Compressor Module (ACCM) (Hybrid only)
-
Battery Energy Control Module (BECM) (Hybrid only)
-
DC to DC Converter Control Module (DC/DC) (Hybrid only)
-
Headlamp Control Module (HCM) (if equipped)
-
Instrument Panel Cluster (IPC) (gateway module)
-
Occupant Classification System Module (OCSM)
-
PCM
-
Power Steering Control Module (PSCM) (if equipped)
-
Restraints Control Module (RCM)
-
Transmission Control Module (TCM) (if equipped)
PINPOINT TEST AE: NO HS-CAN COMMUNICATION, ALL MODULES ARE NOT RESPONDING
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Most faults are due to connector and/or wiring concerns. Carry out a thorough inspection and verification before proceeding with the pinpoint
test. See: Initial Inspection and Diagnostic Overview/Communications Network/Inspection and Verification
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
AE28 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE PCM DISCONNECTED
-
Disconnect: PCM C175b .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to AE42.
No
If the vehicle is equipped with a Headlamp Control Module (HCM), GO to AE29.
If the vehicle is not equipped with an HCM, GO to AE30.
-------------------------------------------------
AE29 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE HCM DISCONNECTED
-
Disconnect: HCM C1600 .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
