Fusion FWD V6-3.5L (2010)
NOTICE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cleanliness is
observed when working with these components or component damage can occur. Always install plugs to any open orifices or tubes.
NOTICE: Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure. For additional information, refer to Fuel System Pressure
Release See: Fuel Filter/Fuel Pressure Release/Service and Repair.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Depress the legs of the retainer clip and position the clip in an outward position.
4. Disconnect the quick connect coupling from the tube.
Connect - Type VI
1. NOTE: Apply clean engine oil to the end of the tube and quick connect coupling O-ring seals.
Install the quick connect coupling onto the tube until fully seated.
2. NOTE: Make sure the retainer clip is fully seated and locked onto the tube by pulling on the quick connect coupling.
Press the retainer clip into the quick connect coupling body until flush and the legs are locked in place.
3. Connect the battery ground cable. For additional information, refer to Battery.
Disconnect - Type VII
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
