Fusion FWD V6-3.5L (2010)
2. Remove the battery tray. For additional information, refer to Battery Tray See: Service and Repair/Battery Tray.
3. Remove the bolt and position the battery cable body ground terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove the starter solenoid terminal cover.
5. Remove the nut and position the battery cable starter solenoid terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
6. Remove the nut and position the starter motor solenoid wire terminal aside.
-
To install, tighten to 5 Nm (44 lb-in).
7. Disconnect the 3 battery cable in-line harness connectors from the engine compartment wiring harness and position aside.
8. Release the 3 battery cable locators from the engine.
9. Remove the bolt and position the battery cable transaxle ground terminal aside.
-
To install, tighten to 10 Nm (89 lb-in).
10. Release the battery cable locator from the transaxle stud bolt.
11. Release the 3 battery cable locators from the LH valve cover.
12. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
13. Disconnect the generator electrical connector and position aside.
14. Disconnect the A/C compressor clutch field electrical connector and position aside.
15. Release the wiring harness retainer from the engine.
16. Remove the battery cables.
17. To install, reverse the removal procedure.