Fusion FWD V6-3.5L (2010)
^
If the park pawl rod guide retaining pin IS NOT PRESENT, continue to the service procedure.
SERVICE PROCEDURE
FUSION AND MILAN
1. Remove the battery tray. For additional information, refer to the WSM, Section 414-01.
ALL VEHICLES
2. Remove the selector lever cable bracket nuts and position the bracket aside.
3. Make sure that the park pawl rod guide is positioned correctly when installing a new park pawi rod guide retaining pin.
a. Install a suitable tool, such as a small pick, into the retaining pin location to align the guide. See Figure 2.
b. If the park pawl rod guide is out of position and can not be aligned, perform the following:
1. Install the guide with the retaining pin cut-out to the bottom of the guide. See Figure 3.
2. Using slight pressure, slide the guide inward until it stops Continue to apply slight pressure and rotate the guide COUNTER - clockwise first
and then clockwise. This will allow the guide to align with the park pawl rod.
3. Make sure that the guide is aligned in the correct position by installing a suitable tool, such as a small pick into the guide retaining pin
location. See Figure 2.
