Fusion FWD V6-3.5L (2010)
15. Remove the 2 bolts and separate the solenoid body assembly from the main control valve body.
Installation
1. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Main Control Valve Body See: Service and
Repair/Overhaul/6F35/Disassembly and Assembly of Subassemblies/Main Control Valve Body. If installing a new main control assembly,
continue with this procedure.
Install the solenoid body assembly onto the main control valve body. Install the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
2. Position the OSS and TR sensor wiring harnesses aside and install the main control-to-transaxle case separator plate.
3. NOTE: Make sure that the manual lever pin (part of the TR sensor) is correctly installed in the manual valve.
Install the main control.
