Fusion FWD V6-3.5L (2010)
2. Position the OSS and TR sensor wiring harnesses aside and install the main control-to-transaxle case separator plate.
3. NOTE: Make sure that the manual lever pin (part of the TR sensor) is correctly installed in the manual valve.
Install the main control.
4. NOTICE: Make sure not to pinch the Output Shaft Speed (OSS) or Transmission Range (TR) sensor wiring harnesses when installing the
main control.
NOTE: Install the different length bolts in the locations noted during disassembly.
Install the main control stud nut and 22 main control valve body bolts. Tighten in a crisscross pattern.
-
Tighten to 10 Nm (89 lb-in).
