Fusion FWD V6-3.5L (2010)
5. Fill the transaxle with clean transmission fluid as specified until the level reaches the bottom of the fill plug hole.
6. NOTE: Clean the area around the fill plug removing transmission fluid that may have spilled on the transaxle case.
NOTE: Inspect the plug and washer for damage and install a new plug if necessary.
Install the fill plug.
-
Tighten to 40 Nm (30 lb-ft).
7. NOTE: The check and fill plug is located on the left side of the transaxle near the front.
NOTE: The transmission fluid is checked and filled by removing the fill plug and adding transmission fluid to the bottom of the fill plug hole.
Start the engine and check for correct forward and reverse operation.
8. Install the underbody cover and 7 screws.
