Fusion FWD V6-3.5L (2010)
12. Position the wheel speed sensor harness bracket and install the bolt.
-
Tighten to 23 Nm (17 lb-ft).
13. Using the Halfshaft Installer, seat the halfshaft into the wheel hub.
14. NOTICE: Do not tighten the front wheel hub nut with the vehicle on the ground. The nut must be tightened to specification before the
vehicle is lowered onto the wheels. Wheel bearing damage will occur if the wheel bearing is loaded with the weight of the vehicle applied.
NOTE: Apply the brake to keep the halfshaft from rotating.
Install a new front wheel hub nut.
-
Tighten to 255 Nm (185 lb-ft).
15. Stake the new nut in line with the keyway to a recommended minimum depth of 1 mm (0.039 in) below the keyway diameter to engage the locking
feature.
16. Install the wheel and tire. For additional information, refer to Wheels and Tires.
Intermediate Shaft
Intermediate Shaft - Front Wheel Drive (FWD)
Removal
