ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Brake Pads > < Rear Disc Brake

Galaxy 2000.75 (04.2000-02.2006)

Rear Disc Brake - Brake Caliper Galaxy 2000.75 (04/2000-02/2006)
Removal and Installation

General Equipment
Brake hose clamp
Materials
Name
Specification
High temperature grease
ESE-M12A4-A 

Removal

CAUTION:
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
  1. Remove the wheel and tire. For additional information, refer to Section  204-04 Wheels and Tires.

  1. Detach the parking brake cable from the brake caliper lever.
    1. Remove the retaining clip.
    1. Detach the parking brake cable.

  1. Loosen the brake hose to brake caliper union.
    1. Using a suitable brake hose clamp, clamp the brake hose.
    1. Loosen the union.

  1. Detach the brake caliper from the brake caliper anchor plate.

  1. CAUTION:
    CAUTION:Cap the brake hose to prevent fluid loss or dirt ingress.
    Disconnect the brake hose from the brake caliper.
    • Rotate the caliper counterclockwise.
  1. Remove the brake caliper.

Installation

  1. To install, reverse the removal procedure.
    • Apply high temperature grease to the brake pad contact points.
  1. Bleed the brake system. For additional information, refer to Section  206-00 Brake System - General Information.

Brake Pads > < Rear Disc Brake