Removal and Installation Removal | -
Remove the front bumper. For additional information, refer to Section 501-19 Bumpers. | | -
Remove the front bumper mounting bracket. - Remove the clips.
- Remove the bolt.
| | -
Remove the fender lower retaining bolt. | | -
Remove the fender splash shield lower retaining bolt. | | -
Remove the fender splash shield front retaining bolts. | | -
Remove the fender splash shield. | | -
Remove the fender lower retaining bolts. | | -
Remove the carbon canister. - Detach the hoses.
- Remove the nuts.
| | -
Remove the fender inner retaining bolt and disconnect the return signal electrical connector. | | -
Remove the fender upper retaining bolts. | | -
Using a suitable knife, cut the adhesive on the A-pillar. | | -
Detach the windshield side trim panel from the fender. | Installation | -
NOTE:Apply suitable adhesive between the fender and the A-pillar. To install, reverse the removal procedure. | | |