LTD L6-200 3.3L VIN X 1-bbl (1983)
Figure 1
5.
Wet down exposed shield back with alcohol/water mixture and position as shown in Figure 1.
6.
Using a rubber "squeegee" or plastic spreader (not fingers) "rub" down shield to force all alcohol/water mixture out from under the shield. Pierce
any air bubbles trapped under shield with a small sharp needle and "rub" down the bubble to seal the hole.
7.
Peel off other half of the protective paper and "rub" down shield. Use same installation technique making sure that no bubbles or alcohol/water
mixture is left under the shield.
PART NUMBER
PART NAME
CLASS
E3DZ-17E838-A
Kit-Shield-Rear Bumper
CG
Stone End Deflector
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY