LTD Wagon V8-302 5.0L (1986)
Instrument Panel Pad Removal And Installation
1. Position the instrument panel pad to the instrument panel and install five screws along the lower edge of the pad (Fig. 16).
2. Install one screw to each outboard end of the pad to the instrument panel.
3. On Ford Crown Victoria, install one pad attaching screw near the upper RH corner of the glove compartment door.
4. Install two pad attaching screws at each defroster opening. Use care not to drop the screws into the defroster opening.
5. Install the glove compartment door.
6. Connect the vacuum supply hose to the vacuum supply.
7. Unplug the heater core tubes and connect the heater hoses to the heater core tubes.
8. Add coolant to the proper cooling system level. Ensure that the correct coolant mixture is maintained.
9. Connect battery ground cable. Check the system for proper operation.
NOTE: On vehicles equipped with Electronic Engine Control (EEC), when the battery has been disconnected and reconnected, some abnormal
drive symptoms may occur while the EEC processor relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn
the strategy.