Ford Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
501-20A Safety Belt System >
< Front Bumper Cover
Mondeo 1997 (08.1996-09.2000)
Mechanical Repairs
5 Body and Paint / 501 Body and Paint
501-19 Bumpers
Description and Operation
Removal and Installation
Rear Bumper Cover
Bumpers - Rear Bumper Cover
Mondeo 1997 (08/1996-09/2000)
Removal and Installation
Removal
4-door and 5-door
Remove the bolts.
Remove the loadspace side trim panels (right-hand side shown).
Remove the left and right-hand side nuts (right-hand side shown).
All Vehicles
Raise and support the vehicle. For additional information, refer to SectionÂ
100-02 Jacking and Lifting
.
Wagon
Detach the bumper from the wheelhouse liners.
One screw each side.
4-door and 5-door
Detach the bumper from the wheelhouse liners.
Remove two nuts and one screw each side.
Unclip the lower center support.
Detach the bumper from the rear fenders.
One screw each side.
All Vehicles
WARNING:
The lower edge of the bumper is very sharp, wear gloves to remove bumper. Failure to follow these instructions may result in personal injury.
Remove the bumper.
Remove four nuts and pull the bumper rearwards to disengage from the side pins.
Installation
Install the components in reverse order.
Mechanical Repairs
5 Body and Paint / 501 Body and Paint
501-19 Bumpers
Description and Operation
Removal and Installation
Rear Bumper Cover
501-20A Safety Belt System >
< Front Bumper Cover