ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Exhaust Manifold RH - 3.0L Duratec-SE (VE6) > < Exhaust Manifold LH - 3.0L Duratec-SE (VE6)

Mondeo 2001 (10.2000-02.2007)

Engine - 3.0L Duratec-SE (VE6)/3.0L Duratec-ST (VE6) - Camshaft Seal Mondeo 2001 (10/2000-02/2007)
In-vehicle Repair

Special Tool(s)

Remover, Crankshaft Seal

303-293 (21-143)

Remover, Crankshaft Vibration Damper

303-338 (21-153B)

Adapter for 303-338

303-338-02 (21-153A-02)

Installer, Camshaft Pulley

303-458 (21-192)

Adapter for 303-458

303-458-01 (21-192-01)
Materials
Name
Specification
Engine Oil - 5W-30
WSS-M2C913-B 

Removal

All vehicles
  1. Remove the engine cover.
  1. Disconnect the battery ground cable.
    For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
Vehicles with coolant pump belt tensioner
  1. Remove the coolant pump belt (engine shown removed for clarity).
    • Rotate the belt tensioner clockwise to release the tension from the coolant pump belt.
Vehicles without coolant pump belt tensioner
  1. Using a suitable knife, cut the coolant pump belt.
    • Discard the coolant pump belt.
All vehicles
  1. Using the special tools, remove the camshaft pulley.

  1. Using the special tool, remove the camshaft seal.
    • Discard the seal.

Installation

All vehicles
  1. NOTE:
    NOTE:Install a new camshaft seal.
    Using the special tools, install the camshaft seal.

  1. Using the special tool, install the camshaft pulley.
Vehicles with coolant pump belt tensioner
  1. Detension the coolant pump belt tensioner, install the coolant pump belt (engine shown removed for clarity).
Vehicles without coolant pump belt tensioner
  1. NOTE:
    NOTE:Install a new coolant pump belt.
    Install the coolant pump belt around the coolant pump pulley and the top of the camshaft pulley (engine shown removed for clarity).
  1. Make sure that the coolant pump belt is correctly positioned into the grooves of the pulleys.

  1. NOTE:
    NOTE:Only rotate the crankshaft in the normal direction of rotation.
    Guide the coolant pump belt onto the pulleys as the engine is rotated (engine shown removed for clarity).
  1. NOTE:
    NOTE:Only rotate the crankshaft in the normal direction of rotation.
    Rotate the crankshaft through 360 degrees.
  1. Check that the coolant pump belt is correctly positioned in the grooves of the pulleys.
    • Repeat the installation procedure if the coolant pump belt is misaligned.
All vehicles
  1. Connect the battery ground cable.
    For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

  1. Install the engine cover.
  1. Initialize the door window motors.
    For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Exhaust Manifold RH - 3.0L Duratec-SE (VE6) > < Exhaust Manifold LH - 3.0L Duratec-SE (VE6)