ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
303-04A Fuel Charging and Controls - 1.8L Duratec-SCi (MI4) > < Coolant Outlet Connector - 1.8L Duratec-HE (MI4)-2.0L Duratec-HE (MI4)

Mondeo 2001 (10.2000-02.2007)

Engine Cooling - Bypass Tube—2.5L Duratec-VE (VE6)/3.0L Duratec-SE (VE6)/3.0L Duratec-ST (VE6) Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Special Tool(s)

Remover/Installer, Cooling Hose Clamp

303-397 (24-003)
Materials
Name
Specification
Lubricant
ESE-M99B176-A 

Removal

Vehicles with 3.0L engine
  1. Remove the engine cover.
    • Detach the retaining clips.
All vehicles
  1. Drain the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

  1. Using the special tool, disconnect the coolant hoses.

  1. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
Vehicles with 3.0L engine
  1. Disconnect the positive crankcase ventilation (PCV) hose from the intake manifold and position it to one side.
All vehicles
  1. Remove the bypass tube.
    • Discard the bypass tube O-ring seal.

Installation

NOTE:
NOTE:Before installing the bypass tube lubricate the bypass tube O-ring seal.
  1. To install, reverse the removal procedure.

303-04A Fuel Charging and Controls - 1.8L Duratec-SCi (MI4) > < Coolant Outlet Connector - 1.8L Duratec-HE (MI4)-2.0L Duratec-HE (MI4)