ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Injector Driver Module (IDM) - Vehicles With: Common Rail Fuel Injection > < Crankshaft Position (CKP) Sensor - Vehicles With: Common Rail Fuel Injection

Mondeo 2001 (10.2000-02.2007)

Electronic Engine Controls - 2.0L Duratorq-Di/TDDi (Puma) Diesel/2.0L Duratorq-TDCi (Puma) Diesel/2.2L Duratorq-TDCi (Puma) Diesel - Cylinder Head Temperature (CHT) Sensor Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Special Tool(s)

Socket, CHT Sensor

303-680 (21-239)

Removal

  1. Disconnect the battery ground cable.
    For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

  1. Remove the upper engine cover.

  1. Disconnect the CHT sensor electrical connector.

  1. Using the special tool, remove the CHT sensor.

Installation

NOTE:
NOTE:Make sure that a new component is installed.
  1. To install, reverse the removal procedure.
  1. Initialize the door window motors.
    For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Injector Driver Module (IDM) - Vehicles With: Common Rail Fuel Injection > < Crankshaft Position (CKP) Sensor - Vehicles With: Common Rail Fuel Injection