| Removal and Installation Removal | | -
Remove the air conditioning (A/C) compressor.
For additional information, refer to: Air Conditioning (A/C) Compressor - 2.0L Duratorq-Di/TDDi (Puma) Diesel/2.0L Duratorq-TDCi (Puma) Diesel/2.2L Duratorq-TDCi (Puma) Diesel (412-03 Air Conditioning, Removal and Installation).
| | | -
Remove the A/C compressor drive plate. | | | -
NOTE:If necessary, remove a seized A/C compressor pulley using a suitable remover. Remove the A/C compressor pulley. - Remove the spacer washers.
- Discard the pulley snap ring.
| | | -
Remove the clutch field coil snap ring. - Discard the clutch field coil snap ring.
| | | -
NOTE:Mark the position of the A/C compressor clutch electrical connector in relation to the compressor housing. Remove the clutch field coil. | Installation CAUTION:Do not tilt the clutch field coil when installing in the A/C compressor. NOTE:Installation position of the A/C compressor clutch electrical connector in relation to the compressor housing. NOTE:Install a new clutch field coil snap ring. NOTE:Install a new A/C compressor pulley snap ring. | | -
To install, reverse the removal procedure. | | | -
Check the A/C clutch air gap.
For additional information, refer to: Air Conditioning (A/C) Clutch Air Gap Adjustment (412-00 Climate Control System - General Information, General Procedures).
| | |
