ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
414-02 Generator and Regulator > < Battery Disconnect and Connect

Mondeo 2001 (10.2000-02.2007)

Battery, Mounting and Cables - Battery Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

WARNING:
WARNING:Batteries normally produce explosive gases which may cause personal injury, therefore do not allow flames, sparks or lighted substances to come near the battery. When charging or working near the battery always shield your face and protect your eyes. Always provide adequate ventilation. Failure to follow these instructions may result in personal injury.
WARNING:
WARNING:Batteries contain sulphuric acid, avoid contact with skin, eyes or clothing. Shield your eyes when working near the battery to protect against possible splashing of the acid solution. In case of acid contact with the skin or eyes, flush immediately for a minimum of 15 minutes and seek prompt medical attention. If swallowed, call a physician immediately. Failure to follow these instructions may result in personal injury.
  1. Remove the battery cover.
    1. Release the locking tang.
    1. Lift the cover.
    1. Remove the battery cover from the hinges.
  1. Disconnect the battery ground cable.
    For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

  1. Disconnect the battery positive cable.

  1. Remove the battery retaining bracket.

  1. Remove the battery.

Installation

WARNING:
WARNING:Batteries normally produce explosive gases which may cause personal injury, therefore do not allow flames, sparks or lighted substances to come near the battery. When charging or working near the battery always shield your face and protect your eyes. Always provide adequate ventilation. Failure to follow these instructions may result in personal injury.
WARNING:
WARNING:Batteries contain sulphuric acid, avoid contact with the skin, eyes or clothing. Shield your eyes when working near the battery to protect against possible splashing of the acid solution. In case of acid contact with the skin or eyes, flush immediately for a minimum of 15 minutes and seek prompt medical attention. If swallowed, call a physician immediately. Failure to follow these instructions may result in personal injury.
CAUTION:
CAUTION:If installing a new battery, only install the specified battery type.
For additional information, refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
  1. Make sure that the battery is installed against the right-hand side of the battery tray.

  1. Install the battery retaining bracket.

  1. Connect the battery positive cable.
  1. Connect the battery ground cable.
    For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

  1. Install the battery cover.
    1. Install the battery cover into the hinges.
    1. Lower the cover.
    1. Engage the locking tang.

414-02 Generator and Regulator > < Battery Disconnect and Connect