| Removal and Installation Worldwide Diagnostic System (WDS) | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| 2. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Floor console side trim panel retaining screw 2 - Floor console side trim panel 7 - PSE module retaining bolt 3. To install, reverse the removal procedure. Removal Details Item 4 : PSE module | | -
NOTE:Do not place excessive strain on the PSE module wiring harness. Detach the PSE module from the heater core and evaporator core housing. | Item 5 : PSE module electrical connector | | -
NOTE:Do not place excessive strain on the PSE module wiring harness. Position the PSE module to one side and disconnect the PSE module electrical connector. - Press the PSE module electrical connector locking tang.
- Release the PSE module electrical connector lever.
| Item 6 : PSE module retaining clip | | -
Using a suitable tool, clamp and support the PSE module retaining clip. | Installation Details Item 3 : Floor console side trim panel retaining clips | | -
Install the floor console side trim panel retaining clips to the floor console side trim panel. | |
