ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Hood Alignment > < 501-02 Front End Body Panels|Specifications

Mondeo 2001 (10.2000-02.2007)

Front End Body Panels - Fender Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

  1. NOTE:
    NOTE:This procedure is for removing the right-hand fender. The procedure for removing the left hand fender is similar.
    Remove the front bumper. For additional information, refer to Section  501-19 Bumpers.
  1. Remove the headlamps. For additional information, refer to Section  417-01 Exterior Lighting.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.
  1. Remove the wheel and tire. For additional information, refer to Section  204-04 Wheels and Tires.

  1. Remove the fender splash shield.
    1. Remove the retaining screws.
    1. Remove the retaining bolts (two bolts).
    1. Remove the plastic fixings (three fixings).

  1. Remove the fender front retaining bolts.

  1. Disconnect the direction indicator electrical connector.

  1. Remove the fender front sound insulator.

  1. Remove the fender inner retaining bolts and the fender lower retaining bolt from the a-pillar.

  1. Remove the fender upper retaining bolt from the a-pillar.

  1. Remove the fender flange bolts and the fender grille opening panel bolt.

Installation

  1. To install, reverse the removal procedure

Hood Alignment > < 501-02 Front End Body Panels|Specifications