| Removal and Installation Removal All vehicles | | -
Detach the exterior mirror trim panel. - Remove the screw cover.
- Remove the screw.
| | | -
Disconnect the exterior mirror control switch electrical connector and remove the exterior mirror trim panel. | | | -
Remove the front door latch remote control handle bezel. - Remove the screw cover.
- Remove the screw.
| | | -
Remove the door pull handle cover. | | | -
Remove the retaining screws. | | | -
Remove the door trim panel retaining screws. | | | -
Detach the door trim panel. | | | -
Disconnect the power window electrical connector and remove the door trim panel. | Vehicles without side air bags | | -
Remove the impact absorption bolster from the door trim. - Discard the impact absorption bolster.
| Installation Vehicles without side air bags | | -
NOTE:Make sure the impact absorption bolster is pushed up against the front door trim panel position ribs. Using WSE-M4G323-A adhesive, bond the new impact absorption bolster to the front door trim panel. - Allow the adhesive to dry before installing the front door trim panel.
| All vehicles | | -
To install, reverse the removal procedure. | |
