ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Front Seat Backrest - Vehicles Without: Climate Controlled Seats > < Seats - Vehicles Built From: 06-2003

Mondeo 2001 (10.2000-02.2007)

Seating - Front Seat Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

  1. Move the seat fully forwards.

  1. Detach the safety belt lower anchor from the underside of the seat.

  1. Remove the seat rear retaining bolt covers.

  1. Remove the seat rear retaining bolts.
  1. Move the seat fully rearwards.

  1. Remove the seat front retaining bolts.
  1. WARNING:
    WARNING:To avoid accidental deployment the air bag control module backup power supply must be depleted. Wait at least one minute after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors. Failure to follow these instructions may result in personal injury.
    Disconnect the battery ground cable.
    For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

  1. Disconnect the underseat electrical connector.

  1. Disconnect the video system electrical connectors (if equipped).
  1. Remove the front seat.

Installation

  1. To install, reverse the removal procedure.
  1. Initialize the door window motors.
    For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Front Seat Backrest - Vehicles Without: Climate Controlled Seats > < Seats - Vehicles Built From: 06-2003