ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Safety Belt Retractor - 4-Door-5-Door > < Safety Belt System

Mondeo 2001 (10.2000-02.2007)

Safety Belt System - Front Safety Belt Retractor Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

  1. Move the seat fully forwards.

  1. Detach the safety belt lower anchor from the underside of the seat.

  1. Detach the door opening weatherstrips from the B-pillar.
  1. Move the safety belt shoulder height adjuster to its lowest position.

  1. Remove the B-pillar upper trim panel.
    1. Detach the locating tangs from the B-pillar lower trim panel.
    1. Remove the screw cover.
    1. Remove the screw.
    • Feed the safety belt webbing through the B-pillar upper trim panel.

  1. Remove the B-pillar lower trim panel and reinforcement plate.
    1. Remove the screws.
    1. Release the clips.

  1. Remove the cowl side trim panel (front seat shown removed for clarity).
    1. Remove the screws.
    1. Release the clips.

  1. CAUTION:
    CAUTION:The bolt securing the safety belt anchor is held captive by a paper washer. The bolt, spacer and paper washer must remain on the safety belt anchor at all times when the safety belt is detached or removed.
    Detach the safety belt upper anchor from the safety belt shoulder height adjuster.

  1. Detach the guide loop from the B-pillar.

  1. Remove the front safety belt retractor.
    1. Remove the bolt.
    1. Lift the retractor to detach the locating tang.

Installation

  1. CAUTION:
    CAUTION:Make sure the safety belt retractor locating tang is correctly located.
    NOTE:
    NOTE:Make sure the safety belt shoulder height adjuster locking control is correctly located on the safety belt shoulder height adjuster.
    To install, reverse the removal procedure.

Rear Safety Belt Retractor - 4-Door-5-Door > < Safety Belt System