ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Power Steering Pump - 2.0L Duratorq-TDCi (DW) Diesel > < Power Steering Pump - 2.0L Duratec-HE (MI4)-2.3L Duratec-HE (MI4)

Mondeo 2007.5 (02.2007-)

Power Steering - Power Steering Pump—2.5L Duratec (VI5) Mondeo 2007.5 (02/2007-)
Removal and Installation

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Remove the following items:
    1. Remove the right-hand headlamp assembly.
      Refer to: Headlamp Assembly (417-01A Exterior Lighting, Removal and Installation).
    1. Remove the accessory drive belt.
      Refer to: Accessory Drive Belt (303-05C Accessory Drive - 2.5L Duratec (VI5), Removal and Installation).
  1. Lower the vehicle.

  1. Position the power steering fluid reservoir to one side.

  1. WARNING:
    WARNING:Be prepared to collect escaping fluid.
    CAUTION:
    CAUTION:Make sure that all openings are sealed.
    • Torque: 10 Nm
  1. Raise and support the vehicle.
    Refer to: Jacking (100-04 Noise, Vibration and Harshness, Description and Operation).
    Refer to: Lifting (100-04 Noise, Vibration and Harshness, Description and Operation).

  1. Position the air conditioning (A/C) compressor to one side.
    Torque: 25 Nm

  1.  
    1. Torque: 25 Nm
    1. Torque: 24 Nm

  1. WARNING:
    WARNING:Be prepared to collect escaping fluid.
    CAUTION:
    CAUTION:Make sure that all openings are sealed.
    1. Torque: 10 Nm

Installation

  1. To install, reverse the removal procedure.
  1. Fill the power steering system.
    Refer to: Power Steering System Filling (211-00 Steering System - General Information, General Procedures).
  1. Bleed the power steering system.
    Refer to: Power Steering System Bleeding (211-00 Steering System - General Information, General Procedures).

Power Steering Pump - 2.0L Duratorq-TDCi (DW) Diesel > < Power Steering Pump - 2.0L Duratec-HE (MI4)-2.3L Duratec-HE (MI4)