Removal and Installation Removal | -
Refer to: Battery Disconnect and Connect (414-01, General Procedures). | | -
CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue. | | -
CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue. | | -
CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue. | | -
Refer to: Cooling System Draining, Filling and Bleeding (303-03 Engine Cooling - 2.5L Duratec-ST (VI5), General Procedures). | | -
Refer to: Front Halfshaft RH (205-04, Removal and Installation). | | -
CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue. Torque: 4 Nm | | -
CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue. Torque: 4 Nm | | -
NOTE:Note the position of the spring washers to aid installation. Torque: 10 Nm | Installation | -
To install, reverse the removal procedure. -
Refer to: Door Window Motor Initialization (501-11, General Procedures). | | |