ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Variable Valve Timing (VVT) Oil Control Solenoid > < Knock Sensor (KS)

Mondeo 2007.5 (02.2007-)

3.5 mm drill bit
Center punch

Removal

Electronic Engine Controls - 1.6L Duratec-16V Ti-VCT (Sigma) - Powertrain Control Module (PCM) Mondeo 2007.5 (02/2007-)
Removal and Installation

General Equipment
Ford approved diagnostic tool
  1. NOTE:
    NOTE:This step is only necessary when installing a new component.
    Download the PCM configuration information into the diagnostic tool, using the Programmable Modules Installation routine.
    General Equipment: Ford approved diagnostic tool
  1. Disconnect the battery ground cable.
    Refer to: Battery Disconnect and Connect (414-01, General Procedures).
  1. Remove the left-hand front wheel and tire.
    Refer to: Wheel and Tire (204-04, Removal and Installation).

Vehicles with PCM security shield
  1. Torque: 3 Nm

  1. General Equipment: Center punch
    General Equipment: 3.5 mm drill bit

Vehicles without PCM security shield
  1. Torque: 3 Nm

Installation

  1. To install, reverse the removal procedure.
Vehicles with PCM security shield
  1. Tighten the shear bolt until the head is sheared off.
All vehicles
  1. NOTE:
    NOTE:This step is only necessary when installing a new component.
    Upload the PCM configuration information into the PCM, using the Programmable Modules Installation routine.
    General Equipment: Ford approved diagnostic tool

Variable Valve Timing (VVT) Oil Control Solenoid > < Knock Sensor (KS)