ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Passenger Air Bag Module > < Driver Air Bag Module
Supplemental Restraint System - Driver Lower Air Bag Module Mondeo 2007.5 (02/2007-)
Removal and Installation

Removal

WARNING:
WARNING:The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 3 minutes before disconnecting or removing any SRS components.
WARNING:
WARNING:Wear safety goggles.
WARNING:
WARNING:Do not probe supplemental restraint system (SRS) electrical connectors.
NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions (100-00 General Information, Description and Operation).
  1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

  1.  
    1. CAUTION:
      CAUTION:The component must only be removed by pushing from behind.
      CAUTION:
      CAUTION:Make sure that equal pressure is applied to the full length of the component.
      Release the clips and at the same time push on the back of the air bag module.
      Torque: 8 Nm

Installation

  1. To install, reverse the removal procedure.

Passenger Air Bag Module > < Driver Air Bag Module