| Removal and Installation General Equipment Ford diagnostic equipment Removal WARNING:The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 3 minutes before disconnecting or removing any SRS components. WARNING:Make sure that the vehicle electrical system is fully depowered and no other power source is connected. WARNING:Wear safety goggles. WARNING:Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions (100-00 General Information, Description and Operation). | | -
Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | | -
Remove the floor console. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation). | Installation | | -
Glue selftapping copper coated foil to the RCM and the electrical connectors. | | | -
To install, reverse the removal procedure. | | | -
When a new RCM is installed, configure the RCM using the diagnostic tool. | | 
