| Removal and Installation Removal WARNING:The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 3 minutes before disconnecting or removing any SRS components. WARNING:Make sure that the vehicle electrical system is fully depowered and no other power source is connected. WARNING:Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions (100-00 General Information, Description and Operation). NOTE:Removal steps in this procedure may contain installation details. | | -
Disconnect the battery ground cable. Refer to: Battery Disconnect (414-01 Battery, Mounting and Cables, General Procedures). | | | -
Remove the B-pillar trim panel. Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). | Installation | | -
To install, reverse the removal procedure. | | | -
Initialize the door window motors. Refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | | |
