Mustang L4-140 2.3L Turbo VIN W FI (1984)
2.
Install rubber O-ring in groove on rack piston.
3.
Position plastic O-ring on tool No. T74P-3504-G, or equivalent, Fig. 17. Slide tool and O-ring onto rack until it is adjacent to rack piston, then
slide O-ring off tool and into piston groove over rubber O-ring.
4.
Apply lubricant C3AZ-19578-A, ESW-M1C87-A or equivalent to rack teeth and to rack surface that will contact protective sleeve T74P-3504-K,
or equivalent.
5.
Place protective sleeve T74P-3504-K, or equivalent, over rack teeth. The protective sleeve will prevent rack teeth from damaging the oil seal, Fig.
18.
6.
Thread protective sleeve over threads on right side of rack, Fig. 18.
7.
Lubricate plastic O-ring and protective sleeve with power steering fluid.
8.
Install large end of tool No. T74P-3504-H, or equivalent, onto rack tooth end of rack. Position tool so that it compresses plastic O-ring properly.
Fig. 19 Installing rack into gear housing. Capri, Mustang