Mustang V6-3.9L VIN 6 (2004)
Ignition Cable: Service and Repair
SPARK PLUG WIRE
Remover, Spark Plug Wire
SPECIAL TOOL(S)
REMOVAL
CAUTION:
-
It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
-
Spark plug wires must be connected to the correct ignition coil terminal. Mark spark plug wire locations before removing them.
1. Using the special tool, remove the spark plug wire from the spark plug using a twisting motion.
2. Twist while pulling upward to disconnect the spark plug wires from the ignition coil.
INSTALLATION
1. CAUTION: Be sure to orient the spark plug boots so the spark plug wires do not contact the exhaust manifold.
NOTE: Apply silicone brake caliper grease and dielectric compound to the inside of spark plug and ignition coil boots of the spark plug wire.
To install, reverse the removal procedure.
