Mustang V6-3.9L VIN 6 (2004)
1
Remove the three shield rivets.
2
Remove the shield.
7. Remove the cotter pin and nut. Discard the cotter pin.
8. CAUTION: Use care not to damage the tie-rod end dust boot.
Using the special tool, disconnect the tie-rod end from the front wheel spindle.
9. CAUTION: To prevent damage to the front suspension lower arm, do not remove the nut from the ball joint at this time.
Disconnect the ball joint stud from the front wheel spindle.
^
Loosen the ball joint stud two or three turns.
^
Sharply rap on the spindle at the ball joint connection to disconnect the ball joint stud.
10. Support the front suspension lower arm with a jack stand.
11. Remove the nut and the ABS sensor wire bracket.