Mustang V6-4.0L (2008)
Front Door Window Motor: Service and Repair
Window Regulator Motor - Front Door
WINDOW REGULATOR MOTOR - FRONT DOOR
Exploded View
Removal and Installation
NOTE: The LH or RH front window motor must be de-initialized, then initialized whenever the front window motor is removed from the window
regulator, a new window regulator and motor is installed, a new window glass is installed or for any operation in which grease or lubricants are applied
to the window regulator or glass run.
1. Remove the door window glass.
2. Disconnect the door window motor electrical connector.
3. Remove the 3 door window motor nuts.
-
To install, tighten to 10 Nm (89 lb-in).
4. NOTE: Make certain not to disturb the jack screw when removing the lower right window regulator nut. This may affect the window adjustment.
Remove the 4 door window regulator nuts.
-
To install, tighten to 10 Nm (89 lb-in).
5. NOTE: Is not necessary to remove the regulator and motor assembly from the door remove the window motor.
Position the door window regulator and motor assembly as necessary to access the door window motor screws.