Mustang V6-4.0L (2008)
Front Subframe: Service and Repair
Subframe - Front
Subframe - Front, 4.0L
Special Tool(s)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 6 pin-type retainers and the upper radiator sight shield.
3. Remove the Throttle Body (TB).
4. Remove the power steering bracket bolt and install the Engine Lifting Bracket Set.
-
To install, tighten to 47 Nm (35 lb-ft).
5. Remove the 2 engine insulator nuts.
-
To install, tighten to 55 Nm (41 lb-ft).
6. NOTE: Using the taller adapters, support the Engine Lifting Bracket Set on the shock towers.
Install the Engine Support Bar.