Mustang V6-4.0L (2008)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry Transmitter Programming
REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING
CAUTION: All remote keyless entry (RKE) transmitters must be programmed at the same time.
1. The vehicle must be electronically unlocked before entering program mode, via the RKE transmitter or the door lock control switch while the
driver door is open.
2. Turn the key from the OFF to the RUN position 8 times within 10 seconds, with the eighth turn ending in the RUN position. If the module has
successfully entered program mode, it locks and then unlocks all the doors.
3. Within 20 seconds, press any button on an RKE transmitter, and the doors lock and then unlock to confirm that the RKE transmitter has been
programmed. Repeat this step for each RKE transmitter.
4. If the door locks do not respond for any RKE transmitter, wait several seconds and press the button again. If the door locks still fail to respond,
refer to Inspection and Verification. Make sure that no more than the maximum number of RKE transmitters are attempted to be programmed.
5. Exiting the programming mode is accomplished if one of the following occurs:
-
Turning the key to the OFF position.
-
20 seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number of RKE transmitters have been programmed.