Mustang V6-4.0L (2008)
7. Remove the LH and RH clevis-to-hydraulic lift cylinder rod bolts.
8. Fully lower the LH and RH hydraulic lift cylinders.
9. Release the LH and RH hydraulic line locators on each side.
10. Disconnect the hydraulic pump and motor assembly electrical connector.
11. NOTE: Remove the hydraulic pump and motor assembly and the LH and RH hydraulic lift cylinders together.
Remove the hydraulic pump and motor assembly.
-
Remove the 2 hydraulic pump and motor assembly nuts.
-
Remove the hydraulic pump and motor assembly and the LH and RH hydraulic lift cylinders.
Hydraulic lift cylinder
12. Remove the hydraulic lines from the hydraulic lift cylinder.
-
Release the hydraulic line retaining tabs to remove the hydraulic lines from the hydraulic lift cylinder.
Motor assembly
13. Remove the hydraulic lines from the hydraulic pump and motor assembly.
-
Remove the hydraulic line-to-motor bolts from hydraulic pump and motor assembly.
Installation
Motor assembly
1. NOTE: Match the numbers that are visible on the hydraulic lines to the numbers that are stamped onto the hydraulic pump and motor assembly to
make sure that the hydraulic lines are lined up to the correct hydraulic pump and motor assembly port.
Install the hydraulic lines onto the hydraulic pump and motor assembly ports.
-
Install and tighten the hydraulic line-to-motor bolts to 14 Nm (10 lb-ft).
Hydraulic lift cylinder
2. NOTE:
-
Match the numbers that are visible on the hydraulic lines to the numbers that are stamped onto the hydraulic lift cylinder to make sure that the
hydraulic lines are lined up to the correct hydraulic lift cylinder port.
-
Make sure that the hydraulic lines are fully seated into the hydraulic lift cylinder.
Install the hydraulic lines into the hydraulic lift cylinder ports.
-
Install the hydraulic line retaining tabs to lock the hydraulic lines into the hydraulic lift cylinders.
Hydraulic system
3. Bleed the hydraulic system. For additional information, refer to System Bleeding. See: Service and Repair/Procedures