Mustang V6-4.0L (2008)
Special Tool(s)
Removal and Installation
CAUTION: To prevent system failure, it is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS
system reset command.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat.
2. Remove the clip and recline handle.
3. Remove the screw at the rear of the cushion side shield. Pull out on the side of the cushion side shield, release the retaining clips and pin-type
retainer and separate the side shield.
Driver seat with manual height adjust
4. Remove the manual height adjust handle center cover.
5. Remove the 2 screws and manual height adjust handle.
Driver seat
6. NOTE: Note wire harness routing for installation.
Disconnect the seat position sensor and separate the pin-type retainer.
All seats
7. NOTE: Note wire harness routing for installation.
Separate the side air bag module electrical connector and wire harness from the power seat track bracket.
8. Release the cushion trim cover rear J-clip, disconnect the power lumbar electrical connector and separate it from the cushion frame.
9. NOTE: Note wire harness routing for installation.
Disconnect the power seat track motor electrical connector, separate the main seat electrical connector and wire harness from the power seat track
bracket and position the wire harness aside.
10. NOTE: Note wire harness routing for installation.
Disconnect the safety belt buckle switch and separate the pin-type retainer from the seat track.
11. Release all cushion trim cover to cushion frame retainers.
12. Remove the 4 nuts and power seat track.
-
Lift the cushion foam pad to access the power seat track nuts.
-
To install, tighten to 36 Nm (27 lb-ft).
13. Remove the bolts and safety belt buckle and bracket.
-
To install, tighten to 42 Nm (31 lb-ft).
14. To install, reverse the removal procedure.
