Mustang V6-4.0L (2008)
^
Install a new brake caliper anchor plate if it is worn or damaged.
Installation
1. CAUTION: Protect the piston and boots when pushing the caliper piston into the caliper piston bores or damage to the piston or boots
may occur.
If installing new brake pads, using a C-clamp and a worn brake pad, compress the brake caliper pistons into the caliper.
2. CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material or damage to components may
occur. Do not install contaminated pads.
NOTE: Install all the hardware supplied with the brake pad kits.
Install 4 new spring clips and the 2 brake pads.
3. Position the brake caliper on the anchor plate and install 2 new guide pin bolts.
^
Tighten to 34 Nm (25 lb-ft).
4. If necessary, fill the brake fluid reservoir with clean, specified brake fluid.
5. Apply the brakes several times to verify correct brake operation.